Knowledge Checks

What is the Internet Protocol?

What are the principal components of the IPv4 protocol (check all that apply)?

ICMP (Internet Control Message Protocol)

IPv4 addressing conventions.

Routing algorithms and protocols like OSPF and BGP.

IPv4 datagram format.

Packet handling conventions at routers (e.g., segmentation/reassembly)

SDN controller protocols.

That's Correct!

That's Incorrect. Try Again

1/11

The IPv4 header.

Match each of the following fields in the IP header with its description, function or use.

Question List:

Version field

Type-of-service field

Fragmentation offset field

Time-to-live field

Header checksum field

Upper layer field

Payload/data field

Datagram length field.

Answer List:

This field indicates the total number of bytes in datagram.
This field contains a UDP or TCP segment, for example.
This field contains the IP protocol version number.
This field contains ECN and differentiated service bits.
This field is used for datagram fragmentation/reassembly.
This field contains the Internet checksum of this datagram's header fields.
The value in this field is decremented at each router; when it reaches zero, the packet must be dropped.
This field contains the "protocol number" for the transport-layer protocol to which this datagram's payload will be demultiplexed - UDP or TCP, for example.

That's Correct!

That's Incorrect. Try Again

2/11

What is an IP address actually associated with?

Which of the following statements is true regarding an IP address? (Zero, one or more of the following statements is true).

If a host has more than one interface, then it has more that one IP address at which it can be reached.

It is not necessary for a device using the IP protocol to actually have an IP address associated with it.

An IP address is associated with an interface.

If a router has more than one interface, then it has more that one IP address at which it can be reached.

That's Correct!

That's Incorrect. Try Again

3/11

What is a subnet?

What is meant by an IP subnet? (Check zero, one or more of the following characteristics of an IP subnet).

A set of devices all manufactured by the same equipment maker/vendor.

A set of devices that always have a common first 16 bits in their IP address.

A set of device interfaces that can physically reach each other without passing through an intervening router.

A set of devices that have a common set of leading high order bits in their IP address.

That's Correct!

That's Incorrect. Try Again

4/11

Subnetting(a).

Consider the three subnets in the diagram below.

What is the maximum # of interfaces in the 223.1.2/24 network?

256

128

There's no a priori limit on the number of interfaces in this subnet.

2**32

Two hosts, as shown in the figure.

That's Correct!

That's Incorrect. Try Again

5/11

Subnetting(b).

Consider the three subnets in the diagram below.

What is the maximum # of interfaces in the 223.1.3/29 network?

128

There's no a priori limit on the number of interfaces in this subnet.

2**32

Three hosts, as shown in the figure.

That's Correct!

That's Incorrect. Try Again

6/11

Subnetting(c).

Consider the three subnets in the diagram below.

Which of the following addresses can not be used by an interface in the 223.1.3/29 network? Check all that apply.

223.1.3.28

223.1.3.16

223.1.3.2

223.1.3.6

223.1.2.6

That's Correct!

That's Incorrect. Try Again

7/11

Plug-and-play.

What is meant by saying that DHCP is a "plug and play" protocol?

No manual configuration is needed for the host to join the network.

The network provides an Ethernet jack for a host’s Ethernet adapter.

The host needs to “plug” (by wire or wirelessly) into the local network in order to access (“play” in) the Internet

That's Correct!

That's Incorrect. Try Again

8/11

DHCP request message.

Which of the following statements about a DHCP request message are true (check all that are true). Hint: check out Figure 4.24 in the 7th and 8th edition of our textbook.

The transaction ID in a DHCP request message will be used to associate this message with future DHCP messages sent from, or to, this client.

A DHCP request message is optional in the DHCP protocol.

The transaction ID in a DCHP request message is used to associate this message with previous messages sent by this client.

A DHCP request message is sent from a DHCP server to a DHCP client.

A DHCP request message is sent broadcast, using the 255.255.255.255 IP destination address.

A DHCP request message may contain the IP address that the client will use.

That's Correct!

That's Incorrect. Try Again

9/11

IPv4 versus IPv6.

Which of the following fields occur ONLY in the IPv6 datagram header (i.e., appear in the IPv6 header but not in the IPv4 header)? Check all that apply.

128-bit source and destination IP addresses.

The flow label field.

The header checksum field.

The header length field.

The options field.

The time-to-live (or hop limit) field.

The IP version number field.

The upper layer protocol (or next header) field.

That's Correct!

That's Incorrect. Try Again

10/11

Purpose of DHCP.

What is the purpose of the Dynamic Host Configuration Protocol?

To get the 48-bit link-layer MAC address associated with a network-layer IP address.

To obtain an IP address for a host attaching to an IP network.

To configure the interface speed to be used, for hardware like Ethernet, which can be used at different speeds.

To configure the set of available open ports (and hence well-known services) for a server.

That's Correct!

That's Incorrect. Try Again

11/11

Knowledge checks

What is the Internet Protocol?

The IPv4 header.

Question List:

Answer List:

What is an IP address actually associated with?

What is a subnet?

Subnetting(a).

Subnetting(b).

Subnetting(c).

Plug-and-play.

DHCP request message.

IPv4 versus IPv6.

Purpose of DHCP.